jnewton83985
Level 1
Level 1
Member since ‎10-29-2021
‎04-24-2024

User Statistics

  • 55 Posts
  • 2 Solutions
  • 135 Helpful votes Given
  • 21 Helpful votes Received
Recent Badges
20 Replies
10 Helpful Vote
10 Replies
5 Replies
1 Helpful Vote
1 Accepted Solution
FirstQuestion
Certifications

User Activity

I have a 3850 stack consisting of (1) 24 port and (1) 48 port running 16.6.9. The 48 port had a hardware failure and was replaced with the exact same model. Since the replacement was added, the stack has gone down 4 times.5/7 at ~ 11:01:02 PM5/10 at ...
I am unable to SSH to our 4500x core switches all of a sudden via putty, cisco CLI analyzer, or from another switch. In the logs, I see the following when I try to SSH to it.Apr 14 15:08:34.476: %SEC-6-IPACCESSLOGP: list SSH_ACCESS permitted tcp 10.2...
Running into an issue that I cannot figure out and looking for help.  Cable modem (bridge mode) -> 1921 router -> 3750 switch -> computers No devices can ping the default gateway:10.5.104.1 The router config was built by another tech but worked at th...
I no longer see a need for our 2911 routers that sit behind our firewalls and I am looking for feedback.  At one point they were used for a T1 connection but that is no longer in use. They are configured for HSRP and OSPF however the OSPF neighbors c...
I am getting the following error on a WS-C3850-48P running 16.6.9 after entering service-policy ouput PM-QOS on the uplink. I'm not trusting any end point markings so the trust boundary begins at the uplink. Invalid queuing class-map!!! Queuing actio...
Community Statistics
Member Since ‎10-29-2021 01:19 PM
Date Last Visited ‎04-24-2024 12:05 AM
Posts 55
Total Helpful Votes Received 21
Helpful Votes From