About jason.davis

jason.davis · 09-27-2011

I have some specific traffic that I am attempting to pull off of VLAN 310 at the router, apply a route-map that sends this specific traffic back down to the switch on VLAN 55 (and the private address) and once it hits the switch apply a route-map on...

jason.davis · 09-29-2011

The down stream traffic goes into the FAP the way your suggesting, I am under the impression for the traffic to be FAP'd on the up and down that it has to go back upstream through the interface that is connected to the switch. Also, still wondering w...

jason.davis · 09-29-2011

1. It is the router doing the routing and the switch is acting at L2?For this function the router is doing the routing and the switch is acting at L2. 2.if so the SVI on the switch is for management?Yes, I however added the VLAN 55 to route the traff...

jason.davis · 09-28-2011

Rick, I appoligize for not being specific enough, I have included a quick drawing to reference as well. The traffic flow for all traffic is going:Protocol Processor (VLAN310) ------> SW -----> Rtr (VLAN 310) -----> Rtr (VLAN1) -------> SW (out to net...

Member Since	‎09-27-2011 01:08 PM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	4

User Statistics

User Activity

Route-map issue

Re: Route-map issue

Re: Route-map issue

Re: Route-map issue