Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I was wondering what could be wrong if i'm trying to configure BGP BFD under logical bundle-ethernet.here's the scenario in short wordsi'm establishing a B2B VRF between 2 GSR routers with IOS-XR 4.2.3 . BGP peering is established over B2B vrfs betwe...
Hi everyone,i need to load balance traffic from R3 going to R1's loopback 1.1.1.1 and at the same time load balance traffic from R3 going to R2's loop back 2.2.2.2how can this be achieved, i always managed to load balance only one of the destinations...
hi everyone,i'm doing this lab with 1 tunnel with 2 path-options specified explicitly... the problem is when the first path is down, the second comes up.. but when the first comes up again.. the second path remains active.. how can i fix this?.. here...
hi everyone,i was setting this ospf lab and as we all know distribute lists only removes LSAs from the router that has the DL on it but it still passes LSA to other routers and they do install this routes in their routing table..here's the scenario, ...
hi there,no, OSPF will not react until the router is rebooted.. but always remember the OSPF prefers loopback interfaces over physical interfaces ip address as a router ID.and it prefers the higher loopback interface ip address as it's router ID.. so...
well, it cuts down to the customer routing.. because having different ASs will definitly change his routing, but let's say that that doesn't matter.giving each site a different AS will make the configuration easier because this will be the default be...
yes, i tried changing the timer to 30 sec but no use.. but you are correct from the CSPF prespective, it's indeed not better than the other pass, but the point is this is labeled as OPTION 1 and the other is OPTION 2 ... isn't option 1 supposed to ha...
