Hi at all,   we have a strange Problem. We have two 6509-Core-Switches with Version 15.1(2)SY. After updating one Core-Switch to Version 15.1(2)SY10 the HSRP doesn't work anymore (we updated the standby-HSRP-switch). Once the Core-Switch becames up, the HSRP is starting switching between active - speak - standby. The following Messages were occuring: %MAC_MOVE-SP-4-NOTIF: Host 0000.0c9f.f0f4 in vlan 990 is flapping between port Te1/3 and port Router %HSRP-5-STATECHANGE: Vlan990 Grp 244 state Active -> Speak %HSRP-5-STATECHANGE: Vlan990 Grp 244 state Speak -> Standby %HSRP-5-STATECHANGE: Vlan990 Grp 244 state Standby -> Active and so on.   After getting back to Version 15.1(2)SY HSRP works fine. Has anyone an idea, what is causing this problem? And what is the port called "Router"? In "show interfaces" we don't have a port or an interface with this name.   Thanks. Kerstin ... View more

Hello, I have a set of config commands in a CLI template to deploy on a switch. For example loggging host 1.2.3.4 no setup express snmp-server community example1 snmp-server enable traps If I deploy this on a 3850 switch, the job fails and stops on the command "no setup express" because this is not a possible command for this switch type. The next line "snmp-server community example1" is no more deployed. In Prime LMS the deployment was a little bit different. The deployment doesn't add the command "no setup express" to the switch, but the following commands are deployed yet. My problem is, I have one config template for different switch types and not all of the contained commands are permitted on all switch types. Is there a chance to deploy the templates in Prime Infrastructure just as in Prime LMS so that it doesn't stop on a failure and process the whole CLI template? Kerstin ... View more

Hello,   we have Cisco Prime LMS 4.2.4 and I added a new switch type C2960X-24TS-L with IOS Version 15.0.2-EX1. I'd like to deploy a baseline template, but it fails: Protocol ==> Unknown / Not Applicable Selected Protocols with order ==> SSH,Telnet,TFTP Execution Result: CM0150 Deploy Baseline template to PRIMARY config on device failed Cause: Operation not supported for generic support devices CM0056 Config fetch failed for xxxxx Cause: PRIMARY-RUNNING config Fetch Operation failed for TFTP. SSH: Failed to establish SSH connection to 10.xxx.xxx.xxx - Cause: Authentication failed on device 3 times. Action: Check if protocol is supported by device and required device package is installed.   The device is reachable via telnet. I think that I installed the latest device packages for LMS 4.2.4. What could be the problem here?   Thanks, Kerstin   ... View more

Hi all, 30 days ago I've installed RME device packages (Consolidated_dev_pkgs_over_RME501) on LMS 4.0.1. Since then the system inventory collection fails with error "Timeout. Make sure that ICServer is running." System inventory polling is successfull. ICServer is running normally. If I start an inventory collection manually, it also fails with the same error regardless of the switch type. If I start a "Detailed device report" for any device, I get a "Server side error". I already restarted the daemon manager as well as the server. The server runs with Windows 2K8 SP2. Regards, Kerstin ... View more