About mscottini

mscottini · 11-14-2017

What is the best option for integrating a new link (ISP B) that has few IPv4 addresses available for NAT? In the scenario it is necessary that IPv4 Internet users can access all services (more than fifty) through ISP B that provides a /56 IPv6. Is it...

mscottini · 07-03-2014

I would like to backup the license file to apply for a fresh installation on the same hardware (3355). Is that possible? I tried resetting the configuration from the CLI and the license was excluded, it was necessary to do a restore.

mscottini · 05-02-2011

Hello,I would like to know if this traffic is correct... (wan link - remote APs)minute:15 minutes:I think that something is wrong... there is a high bandwidth utilization.All APs are configured with h-reap and local switching.All traffic wan link - 1...

mscottini · 12-05-2017

Thanks for your answer!!!

mscottini · 11-15-2017

First off all, thanks for the answer. The firewall is an ASA 5525-x.I think the routing is the easiest part of the configuration.But if the ISP A has a problem, the only way for the IPv4 Internet Users is the ISP B and this company has more than fift...

mscottini · 09-28-2015

So how can we do the layer7 traffic shaping?Thanks

mscottini · 07-09-2015

Hello frmejiugr,The TAC recommended the 8.0.110.16. Do you know if the last version 8.0.120.0 include all the 8.0.110.16 (special build) fixes and 8.0.115.0 too?Regards.

mscottini · 06-23-2015

Nice, I will try it. And the option "EndPoint Attribute Filter", Is it necessary be enabled?

Member Since	‎05-02-2011 05:33 AM
Date Last Visited	‎09-19-2018 07:15 AM
Posts	18

User Statistics

User Activity

IPv4 NAT and IPv6

Cisco ISE license file

Capwap high bandwidth utilization

Re: IPv4 NAT and IPv6

Re: IPv4 NAT and IPv6

So how can we do the layer7

Hello frmejiugr,The TAC

Nice, I will try it. And the