Hi All, I have a ACS 4.2 under windows, I setuped it to authenticate routers by RADIUS and TACACS+ protocols. now I have some devices whitch know only LDAP protocol. How can setup ACS as a ldap server to authenticate those devices?>
Hi all,I have an CS-ACS appliance with 5.2.0.0.26.3 version. There is not any direct solution for connect ldap client to server. I have 3 servers that have only ldap and for authentication I can not use radius or Tacacs+. I need a solution for this p...
Hi all, I remember in ACS 4.2 we can see any command that user type in cisco router console for example after user connect to a router (with AAA commands and ACS) when we saw on log section. when user type "show run" on account log we can see it. b...
Hi All, I want to set an ACS Server 5.1 for authentication from external OTP Server. When I set Profile Shell and other setting and set Cisco Router then I see authentication is pass but authorization is fail so when I set internal user on ACS I se...
Hi all,I have a network with Two 3800 Cisco Routers as Central and many Cisco 2811 Router as Branches. Now I set two Tunnel on each router connection Interface FastEthernet from each 2811 to SubInterface Fastethernet on 3800. I set OSPF as Routing Pr...
Dear Yudong Thank you for your advice. I set my router with this senario and I can see my command in ACS again thank you. aaa new-model aaa authentication login default group tacacs+ local aaa authentication login no_tacacs enable aaa authenticat...
Hi guys,Thank you for your attention, I read all your commend but I think I could not explain my problem good. First of all I find a solution for encryption with QOS that set in follow attachment configuration file. Then Qos is running OK. Encryption...