About burn999

burn999 · 01-09-2008

Reading 'RFC3513: Internet Protocol Version 6 (IPv6) Addressing Architecture' I see:2.5.4 Global Unicast AddressesAll global unicast addresses other than those that start with binary 000 have a 64-bit interface ID field (i.e., n + m = 64), formatted ...

burn999 · 10-06-2011

Hit this same issue upgrading CUC 8.0.3 to 8.6.1a. Changing to one virtual CPU fixed it. THANKS!!!

burn999 · 08-23-2006

I agree the docs are not that great (what happed to cisco?). I'm also with you that you should make that change.The docs do indicate that the Master and Standby GSSM have a copy of the database and talk about being able to promote the standby to mas...

burn999 · 08-22-2006

I just lab'ed this, but isn?t in production yet:Use GSS (I think there are some other cisco devices with GSLB functionality that can do this too) to to health check on the VIP and if the VIP fails the health check (can be a http get or scripted to ch...

burn999 · 08-22-2006

1. Page (1-9)-(1-10) of the 'Cisco GSS Admin Guide' V1.3 = Logically Removing a GSS or Standby GSSM from the Network.Don't F with your Primary GSS.Page 4-28 of the 'Cisco GSS Getting Started Guide' shows you how to cfg a Standby GSSM.I dont see how t...

burn999 · 08-18-2006

I have a GRE tunnel with the most basic possible config:interface Tunnel0 description GRE tunnel bandwidth 44210 ip address 172.X.X.X 255.255.255.252 delay 300 tunnel source VlanXX tunnel destination 172.X.X.XendAnd I get:#sh int tu 0Tunnel0 is up, l...

Member Since	‎08-18-2006 06:05 AM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	6

User Statistics

User Activity

Any issue with IPv6 address mask >64 bits?

Unity Cnxn 8.x upgrade failed

Re: GSS Redundancy Questions

Re: How to 'fail-over' CSS11503-AC when ALL 5 Reals Servers (Ser

Re: GSS Redundancy Questions

Re: Multipoint GRE tunnel with output drops