About dennis

dennis · 09-26-2016

When I restart Aironet 2802i that's powered by SG300-28PP 28-Port Gigabit PoE+ switch, I see the following message: [*09/26/2016 13:47:31.8044] Radio0 not started, not enough POE power [*09/26/2016 13:47:31.8173] DOT11_DRV[0]: set_channel Channel set...

dennis · 09-26-2016

Hi, I have 3 Aironet 2802i where one of them is configured to run Mobility Express. I created a guest network, and when a mac OSX (10.11.6) client joins, I see following pop-up from their web browser. Any suggestions on fixing this?I don't see any o...

dennis · 09-26-2016

We have three Aironet 2802i, where one of them is running Mobility Express. (One of them seems to have hardware issues so we are getting one replaced, but that's a different story..) When configuring a new WLAN on a Mobility Express, what is 'Admin ...

dennis · 09-28-2016

'show ap config 802.11a summary' and 'show ap config 802.11-abgn summary' shows that the radios are all enabled for both of the access points that we have in the cluster. thanks!

dennis · 09-28-2016

Apparently Aironet 2802i has different set of commands.. 'show interface' requires a parameter, and 'show interface summary' or 'show sysinfo' doesn't mention anything about the radio. Which controller are you using? Is it an Mobility Express contro...

dennis · 09-28-2016

Hmm, "sh ip int brief" is not a valid command. Any suggestions on how to check to see if the radios are up from commandline? thanks. Dennis

dennis · 09-28-2016

I think the message might be red herring actually. I am seeing this message towards the end of the boot sequence, and when the AP actually comes up, I can connect to it. Unless there are more than two radios, then they are definitely up and functio...

dennis · 09-27-2016

I don't think the command 'power inline static max 25000' can be run. Here are the options: switcha6ae68(config-if)#power inline limit The port limit of the interface from the point of view of inline power ma...

Member Since	‎09-21-2016 07:35 PM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	14

User Statistics

User Activity

Aironet 2802i Radio0 not started, not enough POE power on switch SG300-28PP

Mobility Express on Aironet 2802i joining guest network problem

Admin State option when creating a new WLAN on Mobility Express

'show ap config 802.11a

Apparently Aironet 2802i has

Hmm,

I think the message might be

I don't think the command