Good Morning Gentlemen We recently setup a CUCM that is working fine and while going through my hardware inventory I noticed that I had a cisco 2811 router with a WIC 1DSU-T1 V1 card on it, this router is not in use  and I will like to start using t...

Hello to All I have a VIC2-4FXO on a Cisco 2911/k9 witch is properly register on CUCM, 1 setup 1 analog line on port 0/1/0 of this wic and I can receive calls fine trough this interface ( i gave it an Attendant DN)  but I'm unable to make calls, I a...