Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can someone please suggest the least expensive device that will support the specs I have listed below? (which isn't about to be EOL)1 WAN - 100MB (ethernet full duplex - allow for DHCP or static)4 LAN - 100MB or possibly 1G - DHCP (Range and/or e...
Where do you set up a Static host translation? let's say (for example) the public address is 64.233.169.147 and I need to map it to 192.168.1.150 where do I set this? I can then set the firewall rules to allow the specific inbound traffic? Please...
so for the time being, until I purchase a Cisco RVL200 4-Port SSL/IPsec VPN Router, I will just port forward and allow the default firewall rules of any, any. Thank You.
I mean more like: ip nat inside source static 192.168.1.254 x.x.87.171 route-map IP_NAT_STATIC_ROUTEMAP_1 extendableI have a couple of servers on the LAN and I need to make sure there are static maps for each of the servers. The port forwarding do...
