About shawn

shawn · 02-20-2018

Hello, I'm planning to replace the AC power source for our AIR-AP1572EAC-A-K9 AP's with PoE+ switches, specifically the WS-C2960X-24PS-L series. Documentation for the AP is not clear; here it states that PoE is supported: https://www.cisco.com/c/e...

shawn · 01-14-2018

Hello, I'd like to get check my understanding of HA and back plane capabilities of this platform. Scenario: One 4507R+E with dual SUP7-E in SSO mode; Version 03.08.00.E Two 10G uplinks, one per SUP connected to two separate WS-C3750X-24T-S with C...

shawn · 02-05-2011

Hello All,I've setup a site-to-site vpn between 2 5505s, with 1 subnet per site directly behind the ASAs.site1 192.168.10.0/24 --- asa 1.1.1.1/24 ------ ISP ------ asa 2.2.2.2/24 --- site2 192.168.3.0/24The VPN establishes connection successfully, bu...

shawn · 12-29-2009

Hello,I'm spec'ing out a new 4506-E with a SUP 6-E for a LAN upgrade. This will be a core switch in the server room, where there are 20 servers. As I understand it, Cisco recommends the Core/Distribution design approach where the servers would be con...

shawn · 12-06-2009

Hello All. I'm looking for some feedback on a network design. We're replacing our 2821 with a 4507 and I have some questions about the best way to implement this. I've attach a simple diagram that shows our current config and the proposed new config....

shawn · 01-14-2018

Thanks for the response, good suggestion, however port one on each sup will be connected to redundant firewalls. Shawn

shawn · 02-06-2011

Hi Jennifer,Thanks for the reply, yes, i didn't do a very goog job sanatizing the config before posting it. During my troubleshooting efforts, I found a post suggesting to add routes on each ASA to the remote subnet to using the outside interface ip ...

shawn · 12-30-2009

Good point on the L2 vs L3. The servers are in a single vlan and we're going to be restricting access via ACL, so an L3 will be used.

shawn · 12-30-2009

Thanks for the comments eveyone, very useful.Redundancy is definitely important and the servers have dual nics so I want to take advantage of that. Looking at the comments, I'm going to scope out two options:1. Single 4507R-E with Dual SUP 6-E and 1 ...

shawn · 12-06-2009

Thanks for the feedback. HSRP is not an option at this time due to budget but we are adding a second SUP IV for some redundancy. The ASA has to stay, its our internet gateway.Cheers,Shawn

Member Since	‎05-18-2006 12:39 PM
Date Last Visited	‎03-14-2019 11:42 PM
Posts	14

User Statistics

User Activity

AIR-AP1572EAC-A-K9 PoE or UPoE

4507R+E SUP7-E Uplinked to Separate Access Switches

ASA 5505 site-to-site vpn not passing traffic

4500 Core/Distribution Design

4507 Design Help

Re: 4507R+E SUP7-E Uplinked to Separate Access Switches

Re: ASA 5505 site-to-site vpn not passing traffic

Re: 4500 Core/Distribution Design

Re: 4500 Core/Distribution Design

Re: 4507 Design Help