Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
This command is not avaiable. These are the options under show license:
R1#sh license ? agent show license agent all Displays All The License(s). call-home Show license call-home information detail Displays Details Of A Given License. evaluation Dis...
R1#conf tEnter configuration commands, one per line. End with CNTL/Z.R1(config)#int vlan 1R1(config-if)#stan?% Unrecognized command
R1#sh license image levelModule Name Image level Priority Configured Valid license-----------------------------------...
Hi,
I want to do it under vlan interface, but it is the same under physical interface.
Output of standby:
R1#show standby ^% Invalid input detected at '^' marker.
How can I check license level?
Thank you
