Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
- Cisco Community
- :
- About farrukh19911
Stats
Member since
01-18-2016
41
Posts
0
Helpful
0
Solutions
03-29-2017
04:22 AM
туннель пропадает и автоматический восстанавливается через некоторое время...
в это время на ZyWALL пишет IKE Packet Retransmit.
... View more
03-29-2017
01:37 AM
А как можно включить логи только для одного PEER? А то при включение дебага так много информации от всех PEER, так как их много....
... View more
Created by
farrukh19911
in Безопасность (Security)
in Безопасность (Security)
03-28-2017
11:53 PM
03-28-2017
11:53 PM
Доброе времени суток.
У меня настроен IPSec Site to Site между Cisco 2811 и ZyWall 35E.
1) Туннель часто засыпает и автоматический восстановится, что не очень то удобно для пользователей, так как сервисы зависают. Прикреплены файлы с настройками. Помогите, пожалуйста, может я что то не так настроил.
... View more
Labels:
Created by
farrukh19911
in VPN and AnyConnect
in VPN and AnyConnect
03-28-2017
03:44 AM
03-28-2017
03:44 AM
Hello everyone.
I have a Cisco ASA 5525x with IOS 9.2.
I want to configure cisco anyconnect vpn on additional WAN-IP.
On interafce is configured 10.10.10.10 on which 443 redirected to dmz.
I need for Anyconnect other IP 10.10.10.11 with the same port 443 (behind nat). Can anyone help me?
... View more
Labels:
03-22-2017
10:26 PM
From local network it is working well. Also PPTP is working from outside without any problem.
I configured with the following settings, but it is not working. May be I missed any parameters?
object network L2TP-SERVER
host 1.1.1.1
nat (dmz,outside) static 46.46.46.35 service udp 1701 1701
object network L2TP-SERVER-500
host 1.1.1.1
nat (dmz,outside) static 46.46.46.35 service udp 500 500
object-group network WAN-IP
network-object host 49.49.49.35
network-object host 49.49.49.36
access-list OUTSIDE_IN extended permit udp object-group WAN-IP object L2TP-SERVER access-list OUTSIDE_IN extended permit esp object-group WAN-IP object L2TP-SERVER
policy-map global_policy class inspection_default
inspect ipsec-pass-thru
... View more
Created by
farrukh19911
in VPN and AnyConnect
in VPN and AnyConnect
03-20-2017
09:46 PM
03-20-2017
09:46 PM
Hello everyone.
I have ASA5525x with 9.2 IOS. Can I forward the L2TP ports to DMZ, where I have configured L2TP Server?
... View more
Labels:
Created by
farrukh19911
in VPN and AnyConnect
in VPN and AnyConnect
03-10-2017
03:36 AM
03-10-2017
03:36 AM
Hello everyone.
I have ASA 5525x with Anyconnect VPN configuring with 444 port.
It worked well without any problem, but now it gives out the following error attached on file. Port 444 is responds to telnet.
Thank.
... View more
Labels:
Created by
farrukh19911
in VPN and AnyConnect
in VPN and AnyConnect
03-07-2017
12:31 AM
03-07-2017
12:31 AM
Hello everyone.
How to use ACL for Anyconnect connections? How to bind an ACL to user?
At all how to restrict remote connections with ACL?
... View more
Labels:
03-06-2017
07:24 PM
I attached the configuration file.
Remind you that except icmp nothing working.
... View more
03-06-2017
03:21 AM
Thanks a lot. It worked.
Now I connected and how to access the server on DMZ? Can you please share any example?
... View more
Created by
farrukh19911
in VPN and AnyConnect
in VPN and AnyConnect
03-06-2017
02:01 AM
03-06-2017
02:01 AM
Good Day everyone,
I have a Cisco ASA 5525. It has an external IP 80.80.80.80 where 80 and 443 ports are redirected to dmz. I need to configure Cisco Any connect, but as you know it needs 443 port, what in my case is not possible.
Is it possible to redirect 443 to another additional WAN IP (70.70.70.70), which is behind NAT? If yes, please share the rule for NAT.
Cisco Adaptive Security Appliance Software Version 9.2(2)4
... View more
Labels:
Created by
farrukh19911
in Other Network Architecture Subjects
in Other Network Architecture Subjects
02-16-2016
02:23 AM
02-16-2016
02:23 AM
Good Day!
How can i solve this problem. When i opened ASA by console there are following errors:
Linux version 2.6.17.8 (kevfox@kevfox-lnx) (gcc version 4.0.2) #5 PREEMPT Mon May 7 18:35:37 EDT 2007 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 000000000009f000 (usable) BIOS-e820: 000000000009f000 - 00000000000a0000 (reserved) BIOS-e820: 00000000000e8000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 000000003fff0000 (usable) BIOS-e820: 000000003fff0000 - 0000000040000000 (ACPI data) BIOS-e820: 00000000fffc0000 - 0000000100000000 (reserved) 607MB HIGHMEM available. 416MB LOWMEM available. DMI 2.4 present. Allocating PCI resources starting at 50000000 (gap: 40000000:bffc0000) Built 1 zonelists Kernel command line: ide_generic.probe_mask=0x01 ide_core.chs=0.0:980,16,32 auto nousb console=ttyS0,9600 bigp hysarea=65536 ide1=noprobe no-hlt -net nic ide_setup: ide_generic.probe_mask=0x01 -- BAD OPTION ide_setup: ide_core.chs=0.0:980,16,32 -- BAD OPTION ide_setup: ide1=noprobe Enabling fast FPU save and restore... done. Enabling unmasked SIMD FPU exception support... done. Initializing CPU#0 PID hash table entries: 2048 (order: 11, 8192 bytes) Detected 1000.062 MHz processor. Using tsc for high-res timesource Console: colour dummy device 80x25 Dentry cache hash table entries: 65536 (order: 6, 262144 bytes) Inode-cache hash table entries: 32768 (order: 5, 131072 bytes) Memory: 744868k/1048512k available (1553k kernel code, 302496k reserved, 348k data, 116k init, 622528k highmem ) Checking if this processor honours the WP bit even in supervisor mode... Ok. Calibrating delay using timer specific routine.. 2000.71 BogoMIPS (lpj=4001421) Mount-cache hash table entries: 512 CPU: L1 I cache: 32K, L1 D cache: 32K CPU: L2 cache: 2048K CPU: Intel Pentium II (Klamath) stepping 03 Checking 'hlt' instruction... disabled SMP alternatives: switching to UP code Freeing SMP alternatives: 0k freed Unpacking initramfs...<0>Kernel panic - not syncing: bad gzip magic numbers
... View more
Labels:
Created by
farrukh19911
in Other Network Architecture Subjects
in Other Network Architecture Subjects
02-14-2016
09:08 PM
02-14-2016
09:08 PM
Good day to all!
Where can i download cisco vpn client for windows 10 x64?
Give some information about Cisco VPN Client supports for windows, please?
... View more
Labels:
02-14-2016
07:41 PM
I changed the scheme. Now pc1 go out to the internet through proxy without any problem.
How can i do, that only smtp and pop request must go through mail server local address from PC1, all other traffic must go through proxy. it is possible to realise with route map?
Because now if i put 192.168.1.2 as proxy on PC1, this PC sends requests to Mail server through Proxy external address and it loads an external channel.
... View more
03-29-2017
туннель пропадает и автоматический восстанавливается через некоторое
время... в это время на ZyWALL ...
03-29-2017
А как можно включить логи только для одного PEER? А то при включение
дебага так много информации от ...
03-28-2017
Доброе времени суток. У меня настроен IPSec Site to Site между Cisco
2811 и ZyWall 35E. 1) Туннель ч...
03-28-2017
Hello everyone. I have a Cisco ASA 5525x with IOS 9.2. I want to
configure cisco anyconnect vpn on a...
03-22-2017
From local network it is working well. Also PPTP is working from outside
without any problem. I conf...
Created by
farrukh19911
in VPN and AnyConnect
03-20-2017
03-20-2017
Hello everyone. I have ASA5525x with 9.2 IOS. Can I forward the L2TP
ports to DMZ, where I have conf...
03-10-2017
Hello everyone. I have ASA 5525x with Anyconnect VPN configuring with
444 port. It worked well witho...
03-07-2017
Hello everyone. How to use ACL for Anyconnect connections? How to bind
an ACL to user? At all how to...
03-06-2017
Thanks a lot. It worked. Now I connected and how to access the server on
DMZ? Can you please share a...
Created by
farrukh19911
in VPN and AnyConnect
03-06-2017
03-06-2017
Good Day everyone, I have a Cisco ASA 5525. It has an external IP
80.80.80.80 where 80 and 443 ports...
02-16-2016
Good Day! How can i solve this problem. When i opened ASA by console
there are following errors: Lin...
Created by
farrukh19911
in Other Network Architecture Subjects
02-14-2016
02-14-2016
Good day to all! Where can i download cisco vpn client for windows 10
x64? Give some information abo...
Public Statistics
| Date Registered | 01-18-2016 08:51 PM |
| Date Last Visited | 08-18-2017 03:54 AM |
| Total Messages Posted | 41 |
.jpg "VIP Advisor"){kind=icon}
