CSR router R9 and R10 are suppose to form site to site IPsec VPN using digital certificate where R12 is the CA Server.
R10#ping 40.0.1.1 so lo0Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 40.0.1.1, timeout is 2 seconds:Packet ...
I am running GNS3, as shown in the diagram, how do I allow R1 in vrf RED to be able to ping to R2 int vrf BLUE?
Why are the no option to create route-target?
NXOS1(config)# vrf context REDNXOS1(config-vrf)# address-family ipv4 unicastNXOS1(config...
I had intermittent ping drop issues which initiate ping from the switch itself when ping to it's own SVI ip address
Switch#show ip int briefInterface IP-Address OK? Method Status ProtocolVlan10 192.168.24.14 YES NVRAM up up
p...
Hi, I am currently using vEdge version 20.3.1. I managed to onboard vEdge to vManage and did not create CSR on vEdge.
As shown in the steos below I successfully onboarded vEdge to vManage. I would like to confirm if there is a need to generate CSR on...
Please help, what configuration is required so that I am able to ping from R3's
192.168.0.2 to R2's interface Gi1
that is running in
VRF INET
with IP address
192.168.1.1/30
Thanks in advanced.
Hi @Harold Ritter
There is no option to enter 'vrf'
NXOS1(config)# ip route 10.10.2.101/32 ethernet 1/2 ?. Sub interface separator/ Slash separatorA.B.C.D IP next-hop address in format i.i.i.i
NXOS1# show run
!Command: show running-config!Running co...
Any clue on the customize class-map and ACL to add?
Please explain why the initial config of policy-map system-cpp-policy do not have any class-map define below it, does that mean it is not in use? However why disabling the police rate 'no police rat...