jtucker

Thank you so much! Simply adding the 'unicast' to the end of the paging-dn 1 line and restarting the...

Thanks for the response. The current CCA installed is 2.2(1), but the system has been in place almos...

All,We have a paging group of roughly 40 phones. 2 of the phones included in this group are 7921G wi...

Thank you so much, that is exactly what I was looking for!Jeremy

We have run into a situation, where if the 2 receptionist phones are using both lines alotted to the...

All,I had posted back in mid-2009 about our 4 7911's being off by 4 hours, well, I just noticed they...

So it has been a while, but I am back on this now. And as it stands, the 4-7911's are now all off 5 ...

Okay, disregard this, I found the fix via a discussion Steven had answered.https://supportforums.cis...

We have a UC520, where they want to enable the option to Press 0 during someones VM and get kicked o...

Not sure if it helps or not, but here is the ephone config for 1 of our receptionists phones. There ...

The following command actually fixed it for me. We ended up have to reboot the entire UC unit after ...

Of if you want to check via CLI, look at the 2nd post on this link, from Marcos.https://supportforum...

Thanks Steven,Once into the telephony-service I am not positive on the syntax required to give me th...

Marcos,This is for the ephone near me, but they all basically look the same.ephone 40 device-securit...

We have roughly 40 7940/7960's and 2 7921's that all display the correct time. However, we have 4 79...