Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to build an EVPN VPWS service between Cisco ASR9K (XR6.4.2. sp 10) and Сisco NCS540 (XR 7.2.2). I have one ASR9K and two NCS540 for the remote site. On the remote site (NCS540) client switch is connected for each PE, and the interface has...
I have issue with ROUTING-FIB-4-RETRYDB_NONEMPTY on my Cisco NCS540fib_mgr[157]: %ROUTING-FIB-4-RETRYDB_NONEMPTY : One or more FIB object(s) have been in IPv4 retry queue for at least 86400 secondsHas anyone encountered this problem? What happes ? sh...
I am trying to build an EVPN VPWS service between Cisco ASR9K (XR6.4.2. sp 10) and Сisco NCS540 (XR 7.2.2). I have one ASR9K and two NCS540 for the remote site. On the remote site (NCS540) client switch is connected for each PE, and the interface has...
I have this topology in our network. Customer1 = NCS1- NCS2= CUstomer2. Between NCS1 and NCS2 we have EVPN. Customer 1 connected to NCS1 witch single active, but Customer 2 connected to the NCS1 and NCS2 via all-active through switch. NCS-1l2vp...
Delete the bridge-domain commit, then create this bridge domain again. Which are you using load-balance for Ethernet-segment ? (active-active or single-active)
I think that we can use load balancing algorithm with only bundle Ethernet. You don`t use I think that we can use load balancing algorithm with only bundle Ethernet. You don`t use with subinterface.
