Hi everyone, I am facing a problem with a cisco 6509 that goes into rommon every time i restart. If i give the command rommon 1> boot it will pick up the IOS on the sup-bootdisk: or bootdisk: and boots up but i dont understand why on reboot it wo...
Sorry Alfred but my problem was resolved by none of the above I tried everything and it may have worked after all but nothing really got it working until i actually took out the fan tray slot gave a nice air-blow to the fan tray and inside the switc...
Well because of down time and laziness my bad...i didnt restart the switch....however...i found the power down this morning and I had to restart the switch....again it was in rommon ..after it restarted i checked the bootvar because I did it as we ...
okay so what you are saying i should do is thisno boot system flash sup-bootdisk:no boot system bootdisk:s3223-ipbase_wan-mz.122-18.SXF10.binboot system sup-bootdisk:s3223-ipbase_wan-mz.122-18.SXF10.bin!write memoryafter this i confirm that in show ...
Thanks for the reply...sorry for the bootvar here it is now... SWITCH1#show bootvarBOOT variable = bootflash:s3223-ipbase_wan-mz.122-18.SXF10.bin,1;CONFIG_FILE variable does not existBOOTLDR variable does not existConfiguration register is 0x2102Stan...
I have actually tried this too and wrote the startup file but still the switch went in rommon. another thing to note that if i am in rommon...rommon wont recognize the sup-bootflash it will only accept rommon 1> boot bootdisk:s3223-ipbase_wan-mz.122...
