About gdamron

gdamron · 10-03-2012

I am trying to add an extention from a remote UC560 to a blast group to the local UC540. The remote ext (82108) rings, and can be answered but no voice traffic is heard on ether side of the call. If the call originates from a FXO port and not a SIP t...

gdamron · 01-24-2012

I am setting up Smart Call Connector Server 2.01.01 and currently stuck at "Download Router Configuration". I will getting an error saying [line vty 0 4] is missing. Do you want to setup required parameters in CME? I've try clicking Yes, but it just ...

gdamron · 01-03-2011

Is it possible to clear the translstions on a router through snmp?CLI Command : clear ip nat trans forced

gdamron · 09-16-2014

I was able make this work in a lab environment. I used the same WLAN for local and FlexConnect. () In the WLAN I checked "FlexConnect Local Switching"() I used two different AP Groups under the WLAN tab for local and flex. I'm not sure this is need.....

gdamron · 10-05-2012

Using the setting:voice class h323 1call start interworkended up causing problems with the SPA525G using the SSL VPN but I was able to get the codec on the multisitechanged. I this point there seems to be no problems.Thanks for you help

gdamron · 10-04-2012

changing the call start on voice class h323 1 worked!It looks like the our provider only supports g711 and g729. We are currently using g711should I try to change the codec on the multisite dial peers or leave the h323 setting in place?

gdamron · 10-04-2012

An update but I'm still no closer:If a call coming from the outside sip trunk is answered at the local site first, and then forwarded to the remote site the audio works on both ends of the call. The problem is still when the outside sip call is answe...

gdamron · 01-25-2012

I've tried a reboot of the server but same prob I was thinking the same thing on the line vty but i can't figure out how to get a "0 4" setup. I tried "line vty 0 4" but it will just write the commands to both the "0" and the "1 4". Plus it won't let...

Member Since	‎07-01-2010 12:07 PM
Date Last Visited	‎05-01-2020 12:02 AM
Posts	10

User Statistics

User Activity

Incoming sip call forwarded through multisite VPN

Call Connector not able to "Download Router Configuration"

clearing nat translations through SNMP Set

I was able make this work in

Incoming sip call forwarded through multisite VPN

Incoming sip call forwarded through multisite VPN

Incoming sip call forwarded through multisite VPN

Re: Call Connector not able to "Download Router Configuration"