Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I have a question in regards to ISCSI boot via an appliance port on a Cisco UCS 6248 fi. The set up currently consists of a NetApp filer (FAS3240) with a direct connection to the FI via an appliance port. The finalised setup will be eventually...
HiRob,Its working now and the blades are accessing the luns. However i have had to apply the following changes:1. Previously i had a multimode VIF of 2 links being 2a and 2b (single virtual IP) connecting the netapp to each FI. The virtual IP was the...
Hi Michael,That was the same white paper of which I have used for the implementation. I've extracted the following errors from the CLI:vnic_id: 5 link_state: Up Initiator Cfg: initiator_state: ISCSI_INITIATOR_READYinitiator_error_c...
Hi Robert,I'm currently using version 2.0(1s) and Cisco M81KR Virtual Interface Card (VIC). In regards to the steps used to setup iSCSI, the attached document was mainly used (starting page 9). In summary:● Created vNICs using expert Mode● Added iSCS...
Hi Rob,The VLAN was created on both the LAN and Appliance sections using different names and same ID. The mac address table of the FI seems to correctly register the mac address of the NetApp storage under the appliance port.Cheers,Osama
