About TODD BENNETT

TODD BENNETT · 06-23-2010

I have a 831 router with the c831-k9o3y6-mz.123-2.XC2.bin software image. I have set the router to accept incoming PPTP tunnels which works fine with Windows XP workstations. When I try to connect via a Vista or Windows 7 machine I get to "Register...

TODD BENNETT · 06-28-2010

I will try your suggestion. I'm not sure how to check to see if MPPE is enabled on a Vista / Win 7 machine. Do you?Thanks again for your help.Todd

TODD BENNETT · 06-23-2010

Are you using a PPTP VPN connection? If so, some routers require you to enable a PPTP passthrough. Its usually on the Admin tab.Todd

TODD BENNETT · 08-28-2002

Jurij,I would think that putting a default route on both ends solves the problem. Do you control both routers? Implementing a routing protocol on both ends works too (i.e RIP, IGRP).Since this is a point to point connection no NAT is necessary.

Member Since	‎08-28-2002 12:02 PM
Date Last Visited	‎10-23-2019 07:52 AM
Posts	4

User Statistics

User Activity

PPTP 742 Error

Re: PPTP 742 Error

Re: Unable to connect VPN using CiscoLinksys WRT54G2 router

Re: Cisco 2500 inbound traffic routing