Member since ‎04-27-2022

User Statistics

  • 18 Posts
  • 2 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
10 Replies
1 Accepted Solution
5 Replies

User Activity

We have a cisco MDS 9148S 16G 48 FC that's no longer under support, but's been running rock solid at our DR site for 7 years now.It's a very static environment but we replaced a dead NetApp last week, which should have been as simple as updating the ...
I have 2 Cisco switches connected via a two port port-channel. No issue. I’ve been tasked with connecting these to a pair of HP switches which are connected via a  two port port-channel. What’s the best way to do this without creating a loop?  Clearl...
I have the following config on both my Nexus primary and my Nexus secondary: interface port-channel310description Dell TOR 1switchportswitchport mode trunkswitchport trunk native vlan 599switchport trunk allowed vlan 551-560vpc 310interface port-chan...
If I have two 10Gig SFP setup in a port channel (vPC) from both my Primary Nexus 5k and my Secondary Nexus 5K going back to my core switch which is a 6807 VSS, so a primary and secondary but it's logically one switch. So one port on the Nexus primary...
We have a Nexus 5K setup as a vPC pair.   I can log into the "primary" do a config update and copy run start saves the config. If I log into the Secondary and make a config change, doing a copy run start results in: Sec# copy run start[##############...
Community Statistics
Member Since ‎04-27-2022 11:41 AM
Date Last Visited ‎03-21-2023 11:51 AM
Posts 18