Azhar Hossen

Hello @Georg Pauwen, Thank you for your response. Indeed, I want to do the load balancing through th...

Hello @Georg Pauwen, My requirement is to balance the traffic load between APs or routers to avoid a...

Hello @Georg Pauwen, Thanks for adding the policy. I understand about the limitations of Packet Trac...

Hello @Georg Pauwen, My question is: Is it possible to configure load balancing on the two routers u...

Hello @Georg Pauwen, Thank you for your response. Please find attached the .PKT file. The credential...

Hello Cisco Expert, Hope you are doing good. I have set up a network using Cisco Packet Tracer 8.1.1...

Hello @Martin L, Okay, thank you for your response. Have a nice day ahead.Regards,Azhar

Hello @Flavio Miranda, Thank you for your response. Actually, I have been able to access the IP addr...

Hello @Flavio Miranda, Please find attached the project. Note that the credential is as follows:user...

Hello Cisco Experts, I came to know that we need to use square brackets “[ ]” when entering IPv6 add...

Hello @Martin L, I tested again with an IPv4 and IPv6 network (Simple network with Network Controlle...

Hello @Martin L, Thank you for your response. Please find attached the PT file in ZIP. Awaiting for ...

Hello Cisco Experts, I have setup a small network in Cisco Packet tracer, consisting of L3 Switch, R...