About salvage210

salvage210 · 12-12-2022

Question:We have an isolated, classified government Call Manager Cluster running 14.0.1(SU2). We have successfully created an SLR request and obtained the authorization code from Cisco TAC.In the event of a catastrophic loss of data that forces us to...

salvage210 · 11-17-2022

Hello,I am upgrading from 14(SU1) to (SU2).The environment is an isolated, classified single cluster of 3 nodes in a lab. I cannot allow Cisco TAC to remote into the system. I have successfully installed (SU2) on all 3 nodes. I have switched to (SU2)...

salvage210 · 11-11-2022

Hello all,When I view the configuration page for any VoIP endpoint in Call Manager 14 (SU1), the entire "Product Specific Configuration Layout" section is missing from the Configuration Page.This section is where you enable the PC port on the back of...

salvage210 · 11-10-2022

Hello all,I recently upgraded one of our clusters to UCM 14.0.1. We want to enable the PC switchport on the back of some of our VoIP endpoints (7975 and 8841 models). The entire "Product Specific Configuration Layout" block for the VoIP endpoint con...

salvage210 · 10-24-2022

Hi all, @jamie ValenciaI have a tiny cluster of 2 nodes in an isolated (classified) gov't environment.While I was away, someone configured Conference Now so that employees could have phone meetings during the pandemic. We have observed that if the P...

salvage210 · 11-21-2022

That seems unlikely. The NAT environment worked perfectly using 11.5 and then when I upgraded to 14 (SU1). It stopped when I upgraded to (SU2). In fact, the Pub and Sub1 were on (SU2) and stopped working with NAT and Sub2 was still on (SU1) and was s...

salvage210 · 11-21-2022

Hi Nithin,Please see my response to Roger, above.

salvage210 · 11-21-2022

Yes, I've successfully accessed the system GUI's in a network environment that doesn't use the NAT'ing.I think the Call Manager is trying to resolve a DNS. Some sort of setting that went back to a default after upgrading. When the browser gives up, i...

salvage210 · 11-17-2022

Upgrading to SU2 fixed the problem with the missing endpoint configurations. I can now view the Product Specific Configuration Layout.The separate problem with the GUI after upgrading is related to NAT'ing in my lab environment and does not impact th...

salvage210 · 11-16-2022

Hey Roger,You're correct, I just realized this. I looked at the db "errors" and it's a mismatch caused by the one Subscriber not having been switched over yet.Whatever the database state, I should be able to log into the switched over nodes. I was ob...

Member Since	‎05-04-2022 09:37 AM
Date Last Visited	‎02-01-2023 12:18 AM
Posts	32
Total Helpful Votes Received	5

User Statistics

User Activity

Specific License Reservation Questions

CUCM 14 (SU2) not loading pages after login

Full endpoint configuration not showing in CUCM 14 (SU 1)

CUCM 14.0.1- Enable PC port on VoIP endpoints

Conference Now- Fast Busy

Re: CUCM 14 (SU2) not loading pages after login

Re: CUCM 14 (SU2) not loading pages after login

Re: CUCM 14 (SU2) not loading pages after login

Re: Full endpoint configuration not showing in CUCM 14 (SU 1)

Re: Full endpoint configuration not showing in CUCM 14 (SU 1)