Member since ‎06-28-2005

User Statistics

  • 19 Posts
  • 0 Solutions
  • 8 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
5 Replies

User Activity

I am trying to configure the new ACS device, but I have challenge to make command set work. Shell profile works fine. Tacacs protocol is used. Could someone shed some light or provide a example, many thanks
I made some change (ACL) via command line yesterday, and after that I was unable to use PDM to manage the PIX even the config was fallbacked to the day before. The PDM always in the status of "loading PIX Device Manager. Please wait..." Is there any ...
Hi,After the network migration, we have experienced a significant slowdown of internet traffic. I want to some general steps to see what cause this issue. Could anyone help? I tried to find the old topics but no luck.Thank you!
Our management network is via VRF, the ip addess of the ACS also exists in the VRF. After the configuration, the ACS seems doesnt work and there is no reports on the ACS. Below is the configuration. Your help is appreciated!client: int vlan 10 ip...
I am puaaed about shell and enable and the acordingly configuration on the client. 1)If I check shell under user group on ACS, I configured aaa authorization exec default group tacacs+ local aaa authorization commands 15 default group tacacs+ local2)...
Community Statistics
Member Since ‎06-28-2005 06:28 PM
Date Last Visited ‎08-18-2017 03:54 AM
Posts 19
Helpful Votes Given To