Hi Folks, anyone know how I can authenticate a user at IP phone (Call Manager) on the AD ,like 802.1x, without installing the Cisco plugin on it?I want something like Radius (IAS) integrated with AD.Regards,
Hi folks, I want to use two ISP?s (Internet_1 and Inernet_2)both I had valid IP?s. I configured the NAT as following:Real IP : 192.168.2.92NAT (Internet_1): 200.252.153.137/32Real IP : 192.168.2.80 NAT (Internet_2): 200.181.58.163/32All my network us...
Try this :CommandPurposeStep 1 rommon 1> set CONFIG_FILE=bootflash:switch.cfgBOOT=bootflash:cat6000-sup720k8.8-3-2.bin,1:Note For Supervisor Engine 32, the file name iscat6000-sup32pfc3cvk8.8-4-4.binDisplays the boot variables.Step 2 rommon 2> BOOT= ...
According TAC even you have only one client at AP it is necessary the QoS??? I agree it is not a problem of QoS but you know the TAC… you must following the procedures. Regards,Ronaldo.
Hi folks, Anyone tried with a AP in autonomous mode? At the WLC if you put the traffic “multicast†to unicast mode the WLC will have problems with CPU and performance for normal traffic, I am assuming using more than 6 clients connected at the sa...
When you change the configuration at controllers to Gold the multicast packets must come market for you have any result. So you need configure a Cos to multicast traffic. I'm having the same problem and I will do QoS for multicast packets soon. I wil...
Hi Sam,I'm having the same issue at a customer the quality of image at the clients in wireless is worst.I had configured in both modes (unicast and multicast) but still having problems, in unicast a little better. The code at my WLC is WLC4400-K9-4-2...
