About mburroni

mburroni · 07-11-2005

I need to find a solution to accomplish the following:- my client has a 2501 router, with one primary circuit to the ISP, 1024K access. it is also using NAT. ip nat outside on the serial interface for outgoing traffic and ip nat inside overload for i...

mburroni · 09-11-2003

Hello!I have a 2610 router with an e1 card model NM-1CE1U. I've connected a channelized E1 where I have 2 circuits of 128K configured and one of 512K to be connected soon, not yet. IOS: 12.3.1a IP onlyI'm running HDLC to connect through these circuit...

mburroni · 04-23-2003

Hi!I have a cisco 2610 configured with ios Version 12.2(10a) (c2600-is-mz.122-10a.bin). 64K DRAM 16K FLASHI have installed a channelized E1 (channel 16 is for in-band signalling).controller E1 1/0 framing NO-CRC4 line-termination 75-ohm channel-gro...

mburroni · 07-12-2005

Thank you very much Sankar! you have helped me a lot.I followed your suggestion and it worked OK. I modified the NAT statements using route-map source instead of access list source. this way it worked when I tested connectivity from nated source to a...

mburroni · 09-19-2003

Hello! thanks for your answer.Note that there is no circuit connected on int ser1/0:2 yet. So this interface is down/down. I configured policy map just for this customer, as you can see on the config, the policy route-map sentence is JUST configured ...

mburroni · 09-18-2003

Tony! thanks for your suggestion, but yes, I've tried removing the access list... with no luch :0(I've also tried changing the E1 card of router. I moved the card to a 3600 router, I've seen the same behaivor... I'm staring thinking this an E1 card p...

mburroni · 09-16-2003

Hello Amit!Thank you for your reply.No, I'm not able to ping neither. I tried it, pinging from my router to the other end but with no results.The serialx/x:x is up and protocol is up but if I do a ping to the ip address of the remote serial, I receiv...

Member Since	‎01-23-2003 11:09 AM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	7

User Statistics

User Activity

Backup Solution Using Dual Lines On Same Router

no ip connection with remote site using channelized e1 circuits

Can't configure E1 channelized circuit at 512K

Re: Backup Solution Using Dual Lines On Same Router

Re: no ip connection with remote site using channelized e1 circu

Re: no ip connection with remote site using channelized e1 circu

Re: no ip connection with remote site using channelized e1 circu