We have a Cisco ASR 1002 router and a stack of Cisco 3850 switches that then feed 90+ buildings. every bldg operates on a separate VLAN.We have one 1gig circuit feeding the router. we want to regulate how much bandwidth a vlan can use.what would be...
I can't get past the setup for the configuration until a proper NTP address is entered into the wizard. In my setup the management CIMC address is on our production network but the maglev wizard will be setup to scan and monitor a SEPARATE and un-li...
i have several 2960X model switches that have lost their IOS on the onboard flash during an IOS upgrade.
i want to use a USB to load or copy the IOS onto the onboard flash but the units that are in Rommon will not recognize the usbflash.
i can see an...
We have a department that is connecting a Slingbox to a network behind a Cisco 1811 that is connected to the internet via a cable circuit. the Slingbox operates on port 5001. how can i get the traffic to the device Slingbox publi...
We did some switch maitenance this weekend and now we are having some weird issues with the Dell printers. the Dell's keep going into an "error" state. this isn't effecting any Lexmark, epson...etc. only Dell's. if they reboot ...
No ACL's on the switches......Only changes to this building......Our site consistes of 100+ switches in 70 buildings...only changed this buildingNo cisco port mac binding used...we use ForeScout for port securityForeScout scans every building and pe...
We push IOS images out to about 2000 Cisco routers here. For some reason this one is being temper-mental. The IOS has a vulnerability so it needed to be upgraded. I already squeezed the flash also so I can't "undelete" it. I am curious whether th...