We need to setup an ASA5505 with two of its switchports on the same vlan attached to two separate sw...

I'm seeing conflicting info about OSPF support on 3750-x IP Base. Licensing page says you need IP Se...

Since I'm using these ports for data, will a HWIC-4T1/E1 run on a 2801?

That document does not specify if all slots in the 2801 support it, only that the card is supported ...

How many of the VWIC2-2MFT-T1/E1 can be used in the 2801, all for data?I know here it mentions how m...

This turned out to be a bug in the providers Juniper equipment that caused a buffer overflow on pack...

I'm trying to export identity certificates from an ASA 5510 to 5520, I'm exporting in pkcs12 format ...

I have a layer 2 circuit (gigabit fiber) from a provider that connects between a datacenter and main...

From what I can tell, there is no way to specify in each group policy which script to run on connect...

So its safe to say that both commands are not valid on the 3750 and 3560s?

I'm not able to set the mtu on an SVI or routed gigabit port on either model. they are running 12.2(...

After plugging in the new lines into each device, and setting up their IPs, create a static route to...

Please provide relevant configs of both ends.

Ok, did a packet capture on the ASA and saw what I expected, internal phone sends packets to real pr...