Dear Expert,Is there a way to create multiple sip trunks between CUCM and Cisco Unified SIP Proxy (CUSP)? How to achieve it without creating multiple IP interfaces on the CUSP module.CUCM: 8.5.1.10000-9CUSP: 8.5.2Thank you,.wan
Dear Expert,The setup is using Cisco Unity 7.0 Build 7.0(2). Currently, I'm experiencing one of my user, who is the non-UNITY subscriber DN (e.g. DN 8409) has its MWI and envelope icons turned on.I'm suspecting mis-configuration on the Unity that som...
Hello,My setup is a Cisco 3845 with NME-NAM-120S module running Version: 4.0(1). I've MetroE interface configured with " analysis-module monitoring " connected to the WAN link.In few occassions, the SNMP Manager SPECTRUM, detected that this MetroE in...
Hello Experts,I've setup NM-NAM v4.0 on 3845 router. I configured external NAM Management Interface and IP unnumbered Integrated-Service-Module. This setup had been working for about 1 month. Then, there was power shutdown incident. The router was re...
Hello SNMP Gurus,I'm looking for the SNMP OID for the "show isdn status" command as shown below, particularly the OID for the number of "Active dsl 0 CCBs". Could somebody share the knowledge?Borneo>sh isdn statusGlobal ISDN Switchtype = primary-net5...
Hello Michael, appreciate your suggestions.1) Yes, we've done this as a temporary solution. The drawback is phones at the same location, have two different regions, which makes the ext mob feature inflexible2) I'll check this out.Many thanks.wan
Hello Michael,This SIP trunk is part of UCCE solution, which used between CVP, CUSP, and CUCM. The requirements:1) To have different codecs for different type of calls, as the phones are at few countries2) To pass different number of digits from CUS...
Hello Brad,After running the query, we got the following error:Server: Msg 208, Level 16, State 1, Line 1Invalid object name 'notificationmwi'.Do you have further comment?Thank you,.wan
Hello Brad,Very appreciate your response. As I only have Web access to the Unity, I'll bring this steps to the Unity Admin, who has access to the OS level.Thank you very much..wan
