About jansait10

jansait10 · 02-01-2011

Hi All,Can anybody help with setting up SIP trunking for Draytel (www.draytel.org) on UC540? The draytel website recommends the following settings:Registrar: draytel.orgOutgoing Proxy : nat.draytel.org:5065I have edited an XML template and have impor...

jansait10 · 02-15-2011

OK Just to update you, after a lot of running around in circles have found out, from the most basic of docs - First Look Labs v1.4 - integrating UC500 into Lan, that the UC500 series will not support SIP Trunks if behind a non ALG firewall/router - W...

jansait10 · 02-13-2011

OK I've issued that command, SIP trunk is still showing as not registered and have also tried to make an incoming call which has not worked. Also interestingly outgoing calls have also stopped working. I have attached the running config after this ...

jansait10 · 02-13-2011

Hi I've run the show running config command andhave attached the output.

jansait10 · 02-13-2011

Hiya,With regards batting, this could be an issue. At the moment the wan port of the uc540 is connected to the lan port of a netgear router. The Wan address for the UC540 is 192.168.8.100. The Router gateway address is 192.168.8.1. This then has ...

jansait10 · 02-12-2011

Hi Vasank,Have had no time this week - was working!! Anyway, Ive done a little more testing and have applied a few more debugs and have found something interesting that may help get to the bottom of this. with debugs trurned on a I am making incomm...

Member Since	‎01-23-2011 08:24 AM
Date Last Visited	‎09-26-2018 08:06 AM
Posts	11

User Statistics

User Activity

SIP Trunk setup for UK Based Draytel

Re: SIP Trunk setup for UK Based Draytel

Re: SIP Trunk setup for UK Based Draytel

Re: SIP Trunk setup for UK Based Draytel

Re: SIP Trunk setup for UK Based Draytel

Re: SIP Trunk setup for UK Based Draytel