About hannes1967

hannes1967 · 11-03-2022

I start AnyConnect default configuration and can enter username and password.Authentication works, but not authorized to open full tunnel.Please check debug messages below.Now I try SSL-VPN with anyconnect to Cisco 1111!Getting following debug messag...

hannes1967 · 06-08-2022

Dear friends, I need to summarize routes from the backbone area to connected areas! The line in the config of the ABR looks like: router ospf 2area 0 range 10.4.0.0 255.255.0.0area 1 range 10.2.0.0 255.255.0.0 The routing table on a router in...

hannes1967 · 11-05-2022

Thanks!The document describes the way with webvpn!I use „crypto ssl“ commands.I will provide the config etc. tomorrow!cheers, Hannes

hannes1967 · 11-03-2022

I have the same problem!any solutions?

hannes1967 · 06-09-2022

Thank you very much!

hannes1967 · 06-08-2022

Dear Friends, now I tested on GNS3 and I have a solution! Thank you all! Please see also att image001.png, which is not complete! My mistakes in due to misunderstanding of OSPF: I tried to summarize the network 10.4.1.1 which is in area 8!The sum...

hannes1967 · 06-08-2022

It works, when I use the range command in d4, but in the real network I don’t have responsibility on that ABR! Thank you very much, I now have a better understanding!

Member Since	‎06-08-2022 12:38 AM
Date Last Visited	‎11-30-2022 12:05 AM
Posts	13
Total Helpful Votes Received	10

User Statistics

User Activity

SSL-VPN with AnyConnect to Cisco IOS 17.6.4

Route summarization with range from area 0 to a outside area

Re: SSL-VPN with AnyConnect to Cisco IOS 17.6.4

Re: Cisco CSR 1000v Anyconnect SSL VPN setup issues

Re: Route summarization with range from area 0 to a outside area

Re: Route summarization with range from area 0 to a outside area

Re: Route summarization with range from area 0 to a outside area