Hi Ronny,Remove command "service mgcpapp" command from the dial-peer. We dont need that command from 12.3(7)T and later.If above does not work please capture debug isdn q931 for outbound/incoming call.   Also sh ccm-manager output in srst mode.Thanks...

1. Please try "connection plar opx 614". 2. Disconnect problem is a very basic problem with FXO. As you have connected PBX to the FXO ports so i will suggest you to move to ground start. Because in GS we don't face disconnect supervision problem. If ...

Hi Rob,According to the debug the called number is "47145". However in your last post you said you are dialing 130 and than translating it into 3297145.The call is disconnecting with the cause " No route to destination" which means you have not confi...

Hi,CSCdt60512. is a Duplicate of CSCdt28344.Sysptomps and Workaround.On The Cisco Media Gateway Controller Software Release 7.4(11) if a a Q931 progress message is received in response to a Q931 setup message on the NI2 interface between the SC2200 ...

Hi,Please post snapshot of dial-peers from other H323 router.Alsodebug voip ccapi inout (from both the routers)debug translation detail ( from origination router )CJ