About wcjiang

wcjiang · 08-16-2013

Hi, I had configured an 871 to use PPPoE before. Now I tried to use the same configuration on a new 881, I was able to connect to the Internet from the router, but my PC behind the 881 cannot ping any public address except the one on the WAN interfac...

wcjiang · 10-28-2009

Hi, I have a seemingly simple problem, wonder if anyone has a solution. I registered all 6 lines of my 7960 SIP phone under one extension. When a second call comes in, it is laid on top of (and covers) the first call on the screen. I'd prefer to have...

wcjiang · 08-22-2013

Thank you very much, apparently with the new firmware ip nat outside needs to be under the Dialer interface. I ended up installing CCP on my PC and using that to generate the basic commands.

wcjiang · 08-16-2013

Thank you, I will try that when I get to the office next week. I did type in pppoe enable group global, but when I ran "show running-config" this line was not shown, I was wondering why. I assumed it was the default. I also tried changing Dialer1 to ...

wcjiang · 08-16-2013

Thank you for your reply, I did have that in there, somehow I didn't paste that in the post above: ip nat inside ip virtual-reassembly ip route-cache flow ip tcp adjust-mss 1452I started with a working configuration for DHCP and modified the WAN inte...

Member Since	‎10-28-2009 06:42 PM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	5

User Statistics

User Activity

Problem configuring 881 for PPPoE

Display multiple incoming calls on separate lines of the screen

Problem configuring 881 for PPPoE

Problem configuring 881 for PPPoE

Problem configuring 881 for PPPoE