About dan

dan · 07-23-2010

Hello,We are working on TE within our MPLS environment and want to employ CBTS. I have configured this according to the "MPLS Traffic Engineering: Class-based Tunnel Selection" doc. The tunnels are up but do not seem to be recognizing the configure...

dan · 05-22-2010

Here is the breakdown:We are running CallManager 4.3(2)We have multiple clusters connected to a gatekeeper using H225 Gatekeeper controlled trunks.Calls between clusters are working fine except for one group of phonesThese phones are remote site to t...

dan · 05-16-2010

I am running CalManager 4.3(2) and we are having the following issue. Please see attached picture for basic layout.ConfigurationCCM B is connected to Old GK using a H225 trunkCCM A is connected to New GK using an H225 TrunkRemote zones are configure...

dan · 01-11-2010

Here is my scenario:The customer would like the Front desk phone to ring for 20 secondsIf no answer between the hours of 0800 and 1700 the call should roll to a hunt group for all engineersIf no answer there it will forward to the answering serviceIf...

dan · 01-07-2010

Hello All,I have Intercom configured on some phones in our lab system and it is working as advertised.What I am trying to do now is figure out how to setup a button on the phone that acts as a targeted or speed dial intercom button. This way all som...

dan · 05-25-2010

There was a combination of issues with asynchronous routing and firewalls. We are up and good now. Thanks for the help!

dan · 05-22-2010

I am still trying to gain access into the other Cluster A CUCM. I was thinking Codec negotiation also. I am set to use G.729 but blew it out to Swideband so it should negotiate any codec the other end is advertising but I still got a fast busy. I ...

dan · 05-17-2010

Also, to take the gatekeepers out of the equation, I built an ICT between CCM A and CCM B. I am getting the same call behavior while routing over it as I was when routing through the gatekeeper.

dan · 05-16-2010

Yes, SilenceI activated MOH and set to use G.729When you place the call from CCM B to CCM A you can put calls on hold and resume with no issue. MOH works When you call from CCM A to CCM B and you try to place a call on hold the call fails.

dan · 05-16-2010

The Gatekeepers are not the WAN routersG.729We do not use MOH

Member Since	‎11-02-2009 08:07 AM
Date Last Visited	‎02-25-2021 10:57 PM
Posts	23
Total Helpful Votes Received	5

User Statistics

User Activity

MPLS CBTS TE - Tunnel not routing EXP properly

Fast Busy During Intercluster Call

Hold Fails - H225 GK Controlled Trunks

CUC 7.x - No Ringback When Releasing to Switch...

CUCM 7.x - Targeted/Speed DIal Intercom Question

Re: Fast Busy During Intercluster Call

Re: Fast Busy During Intercluster Call

Re: Hold Fails - H225 GK Controlled Trunks

Re: Hold Fails - H225 GK Controlled Trunks

Re: Hold Fails - H225 GK Controlled Trunks