About CliveG

CliveG · 10-27-2022

I have 2 x 1gbps upstream LAG to Provider and it is heavily utilising the following on the ports:Port 1 - 100% with dropped packetsPort 2 - 2% UtilisationCisco's default hash algorithm for Port-Channels appears to be IP based and therefore will utili...

CliveG · 10-03-2022

If I have a customer who co-locates on my network with a couple of servers and I configure a subnet, what's the best way to allow them access via teamviewer or similar just to their particular servers and no other devices on my network?So, it would l...

CliveG · 09-29-2022

Background: Inherited poorly configured network that has only one upstream link (Single point of failure).Current Core topology: See attached diagram.Problem: All routing goes to Manchester. What happens if the link to Manchester fails?Resolution Req...

CliveG · 08-09-2022

HiI have a network that has 2 x C6880X Switches in a VSS and this network must be up, always. A streaming environment. I am in the process of building a physical Lab to replicate the current live environment. I have one issue though, I need to be abl...

CliveG · 06-23-2022

I have read a previous document with relevance to this, however that document is from an ISP perspective and I need this from a Customer perspective. I will attach a diagram to show the requirements: Note: This is how it will be when completed:3 x Da...

CliveG · 11-01-2022

I will need to check exactly what is going out, but as well as VPN we have Multicast, Data etc.This connection is an eBGP peering to multiple other peers within the LINX LON1 LAN. All I know for sure, curerntly, is that one link is heavily utilised a...

CliveG · 11-01-2022

Strange. When working from home yesterday the command "show etherchannel" was not available, yet today, I am in the office and it is available. So, here is the output of the commands:show etherchannel 22 port-channelPort-channel: Po22 (Primary Aggreg...

CliveG · 10-31-2022

Configuration is very basic:Physical interfaces:no switchport, no ip address, no lldp transmit, no lldp receive, no cdp enable, channel-group 22 mode activePort-channel 22:no switchport, <Mac-Address>, ip address xxx.xxx.xxx.xxx xxx.xxx.xxx.xxx, ipv6...

CliveG · 10-31-2022

There is no Etherchannel option on the switch.This is a layer 3 port-channel. The config is the usual on the physical interfaces of the following:channel-group xx mode activeAnd then on the port-channel is the IP Address and the "no switchport" comma...

CliveG · 10-05-2022

All good. Completed. Created the VLNAs and also the Multicast and the subnet. All working

Member Since	‎06-14-2022 12:28 PM
Date Last Visited	‎11-02-2022 01:09 AM
Posts	20
Total Helpful Votes Received	15

User Statistics

User Activity

VSS LAG C6880X

Configure external access

DC Failover on same VSS (C6880X Chassis)

Cisco VSS - Standby Configuration

Datacentre failover design - recommendations

Re: VSS LAG C6880X

Re: VSS LAG C6880X

Re: VSS LAG C6880X

Re: VSS LAG C6880X

Re: Configure external access