About Adrian Mihailov

Adrian Mihailov · 07-30-2010

Hello,We have a H-REAP setup with 2 SSIDs "WLAN_Secure" and "WLAN_Guest".The controllers are running version 5.2The WLAN_Secure works fine for all users, but in a remote site the guest users can't associate to the "Guest" network.The guest network us...

Strange DHCP problems for guest users · 07-15-2010

Hi All,I'm having problems with the DHCP assignments to the guest wireless users in a site.I'm using a H-REAP setup with 3 WLCs and a number of APs that support H-REAP(1140, 1240).The remote sites are spread all over Europe.One of the WLC is used as ...

Adrian Mihailov · 07-06-2010

Dear All,We have an AIR-LAP1142N-E-K9 deployed in a H-REAP setup.This AP already got the configuration from the WLC when it was deployed at a remote site.Now we moved it to another site, but it doesn't appear in the WCS and i don't see any CAPWAP de...

Adrian Mihailov · 07-20-2010

Hi,No, i haven't received a response that works for my case.I had to send the AP back to the site from where it got his configs and reset it from the WCS.I'll note your solution and i'll test it the next time i encounter an issue like this one.Thanks...

Adrian Mihailov · 07-12-2010

Hi,After the reset to factory defaults, the AP boots with the /c1140-rcvk9w8-mx image, as you can see below.Problem is, the configuration isn't deleted.button pressed for 9 secondsprocess_config_recovery: set IP address and config to default 10.0.0.1...

Adrian Mihailov · 07-07-2010

I can get out of the ROMMON mode, that's not the problem.Problem is that the config file is not reset to factory defaults.After the reboot you can see that it uses the old config file.It has the hostname "BEDESAP8" which was the old hostname.Also the...

Adrian Mihailov · 07-07-2010

I tried that reset procedure, with the MODE button pressed for 10 seconds, but it doesn't work.The enable password is not reset, i tried "Cisco" but it doesn't work.I receive the following message after releasing the button:button pressed for 9 secon...

Adrian Mihailov · 07-06-2010

Is there any way to clear the Lwapp config from ROMMON?I tried yesterday to use the "Cisco" as the enable password, but it didn't work.I will try also today, and i will capture the complete logs from Putty.

Member Since	‎09-14-2008 03:28 AM
Date Last Visited	‎10-09-2017 11:58 AM
Posts	9
Total Helpful Votes Received	10

User Statistics

User Activity

Guest clients not associating

Strange DHCP problems for guest users

Reset to factory default doesn't work on 1142 AP

Re: Reset to factory default doesn't work on 1142 AP

Re: Reset to factory default doesn't work on 1142 AP

Re: Reset to factory default doesn't work on 1142 AP

Re: Reset to factory default doesn't work on 1142 AP

Re: Reset to factory default doesn't work on 1142 AP