About freeman6351

freeman6351 · 01-15-2021

Hi Georg, The "Provider Network" in the diagram is not an ISP in this case and is a simplification o...

freeman6351 · 01-15-2021

Hi @paul driver Is it possible for the REMOTE1 router to be configured with a static VTI IPSec inter...

freeman6351 · 01-15-2021

Hi Georg,When NAT Transversal feature is used on an IPSec VPN, ESP and AH packets are wrapped/encaps...

freeman6351 · 01-13-2021

Hello Everyone! I need to establish a site to site/L2L VPN tunnel over a network segment that does n...

freeman6351 · 02-28-2018

Hello Everyone!! Please see attached network diagram. I have a working IOS configuration to NAT traf...

freeman6351 · 11-07-2016

Hello, I tried the configuration adjustments above, but it still would not NAT correctly. I removed ...

freeman6351 · 11-06-2016

Hi! The purpose of the secondary IP on G0/2 is just as you interpreted. It is the next hop for the s...

freeman6351 · 11-04-2016

Hello Cisco Support Community!!! Please reference the attached diagram and router configurations. I ...

freeman6351 · 06-04-2016

Yes, both primary and failover hop routers have public ip addresses from both ISPs on the same subne...

freeman6351 · 06-03-2016

The destination router is not a Cisco, but the rest are.

freeman6351 · 06-03-2016

Philip, Per my original post, adding a routing protocol isn't really an option either. Couldn't I ju...

freeman6351 · 06-02-2016

Philip, Thanks for the reply, but DMVPN isn't an option. Any other suggestions/input?

freeman6351 · 06-02-2016

I'm hoping someone can help give advice and point me in the right direction. I have a single Cisco 1...

freeman6351 · 04-21-2016

I have the following scenario I need help understanding/resolving: PC1 is connected to a Cisco route...

freeman6351 · 02-17-2016

I've run into some routing issues and hope someone can help. I have a new 1921 router setup which re...

Re: ISR 4331 NAT configuration issue for IPSec VPN tunnel