Hi All,
I have a very simple configuration of L2TP tunnel to a vpn providers.
Source is internal IP (192.168.0.X) and destination to VPN provider server.
I have done a policy based routing where only on vlan traffic goes via VPN Virtual-PPP 1 int...
Yes and I already have that in the route-map where I add the next hop per VLAN.
So that is in place - not sure if there is something else which is dropping the connection
30.30.30.1 is source network not the destination network.ip route destination_network_# [subnet_mask] IP_address_of_next_hop_neighbor [administrative_distance] [permanent]
destination_network_#[subnet_mask]
This is the first parameter. It specifies t...
Understand - But if you see my route-maps I am doing policy based routing where I set the next destination address.
I want to route one VLN 305 via VPN tunnel (10.10.1.1) and all other via ISP (192xxxx).
What do you think the solution might be then?
...
Hi Markeelen,There is a firmware for 1800 seriers router when you connect to BT network. I faced same issue and once upgraded It was working absoultely fine. It is something like 'vdsl.bin.---'''Best to to upgrade to EHWIC if you have some buget Than...
