Hello everyone,I recently ran an upgrade on my 6509-E's and when the first switch came back up, 3 of the 10/100 switches that were in the chassis did not power on. After further investigation, these models are not supported by this latest...
I am setting up a few vservers using the primary and backup serverfarm configuration.I've been asked by our systems admins if there is some way that we can be notified via Email when the primary fails and the backup becomes active, and also when the ...
I'm trying to get LMS4.0 trial to see a few of the devices on my network so I can evaluate its worthiness for a fullscale purchase. I made it through some preliminary issues getting the site up etc..which is expected. However, now I am trying to add ...
Thanks for the reply.That makes sense. I didn't think there was any mechanism built in.We are using monitoring software (SNMP). Is there some resource available that shows what I need to do to configure these specific traps so I can get the behavior ...
Ok, so I think I've made it through part of that hurdle...but now the devices are "unreachable". I dont know how they can be managed but unreachable. That is confusing. Again, any assistance would be greatly appreciated!