Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
- Cisco Community
- :
- About lferral
Stats
Member since
02-07-2003
4
Posts
0
Helpful
0
Solutions
04-12-2005
03:50 PM
Excuseme I have tha same question, I have specified the priority parameter in one link, and when there is not matches with the traffic specified in the access list, all the traffic is used by other applications, I dont undestand if you say that when you use priority the bandwith specified always will be reserved used or not. thanks
... View more
Created by
lferral
in Other Network Architecture Subjects
in Other Network Architecture Subjects
02-11-2003
11:08 AM
02-11-2003
11:08 AM
Did you change the L2 protocol in the AS400 Ethernet Interface or in the Switch port were the AS400 is connected? My AS400 expert doesnt know were he can change in the AS400 parameters. I will appreciate your response.
... View more
Created by
lferral
in Other Network Architecture Subjects
in Other Network Architecture Subjects
02-11-2003
10:56 AM
02-11-2003
10:56 AM
We are using ARPA as L2 protocol in AS400 interfases, and we had the problem. Like a "Solution" we changed the 3550-48 switch, we installed a 2948, and the problem was solved, by the moment. I dont know if the switches has a diferent structure. Maybe the problem will be back.
... View more
Created by
lferral
in Other Network Architecture Subjects
in Other Network Architecture Subjects
02-07-2003
04:20 PM
02-07-2003
04:20 PM
I have a lan switch (3550-48) with 4 Hosts AS400 connected, and a Cisco router 2600. The Cisco router is connected via WAN link to the Enterprise IP Network. The 2600 is the default gateway for AS400 hosts. Frecuently cannot reach the AS400 via Telnet, ping, etc. from the Enterprise IP network, But i can reach the AS400 from the 2600 router or; form his neighbor pingging from the Wan Interfase connected to the 2600. If i clean the arp tables in the 2600 router, Now i can reach the as400 from any place of the network. As a patch, I set the ARP TIMEOUT to 60 seconds in the 2600 router to clear arp table each 1 minute. I will Apprieciate any comment
... View more
Labels:
04-12-2005
Excuseme I have tha same question, I have specified the priority
parameter in one link, and when the...
02-11-2003
Did you change the L2 protocol in the AS400 Ethernet Interface or in the
Switch port were the AS400 ...
02-11-2003
We are using ARPA as L2 protocol in AS400 interfases, and we had the
problem.Like a "Solution" we ch...
Public Statistics
| Date Registered | 02-07-2003 03:49 PM |
| Date Last Visited | 08-18-2017 03:50 AM |
| Total Messages Posted | 4 |
