About CChambleeJr

CChambleeJr · 02-23-2016

Hello all. I am having trouble getting inbound SIP calls to reach voice mail boxes after call-forward noans. I have two working CME routers, each as a stand-alone PBX. I have a SIP trunk configured between them, and can place calls from one CME to...

CChambleeJr · 02-24-2016

Thanks to Nadeem Ahmed, he identified the lack of a transcoder between the CME's G.729 codec and the CUE module's G.711 codec. Problem resolved!

CChambleeJr · 02-24-2016

Made following changes: dial-peer voice 31 voip description Outbound SIP to CME-2 - Local destination-pattern 4... session protocol sipv2 session target ipv4:10.0.185.71 dtmf-relay rtp-nte!dial-peer voice 32 voip description Incoming from CME-2 desti...

CChambleeJr · 02-24-2016

In trying to think this thing through, I can't see where any IP routes are lacking, because the two CMEs are signalling each other over the 10.0.185.0 network (SIP trunk). I can call from phones on CME#1 to phones on CME#2, and have talk paths. It's ...

CChambleeJr · 02-24-2016

The phones on CME#2 (where the test calls are originating from), and CME#2 itself are on 172.16.2.0. The target CME (#1) is on 172.16.1.0, and its phones are are on 172.16.100.0. The SIP trunks are on a different interface, and on 10.0.185.0. Voicem...

CChambleeJr · 02-24-2016

Applied recommended changes. The symptom has changed now. Note ccsip messages debug: *Feb 24 19:18:06.506: //253/C1E8CDC882FA/SIP/Msg/ccsipDisplayMsg:Sent:SIP/2.0 503 Service UnavailableVia: SIP/2.0/TCP 10.0.185.71:5060;branch=z9hG4bK9E1102From: "S...

Member Since	‎02-23-2016 02:00 PM
Date Last Visited	‎08-18-2017 06:46 PM
Posts	8

User Statistics

User Activity

Inbound SIP Calls Not Going to VM

Thanks to Nadeem Ahmed, he

Made following changes:

In trying to think this thing

The phones on CME#2 (where

Applied recommended changes.