About Philipp Maihoefer

Philipp Maihoefer · 09-06-2016

Hello, are there any plans to support the Nexus 5648Q in Cisco Prime Infrastructure? This model is not really new, but also with recently released device pack 3.1.3 it isn't supported in PI. I'm asking for a customer which is currently using >15 of...

Philipp Maihoefer · 06-25-2015

Hi Community,I need to decode a "show stacks " output. While doing some research and reading AFROJ AHMAD statement in post (Getting High CPU S720 due SNMP Prime) i figured out that i need to find some "symbols.gz" files for the corresponding IOS ver...

Philipp Maihoefer · 02-01-2012

Hi,I have here two Nexus7k chassis and I want to make use of the CFS feature. As far as I understood, it is using multicast for synchronising the configuration on both chassis. Both SUP management interfaces are connected to an old 3550 rackswitch an...

Philipp Maihoefer · 10-09-2011

Hi,i would like to know if the ASA is still handling ipv6 in software (like the FWSM for example), or is it using its powerful hardware to handle the ipv6 traffic?Best regardsPhilipp

Philipp Maihoefer · 03-28-2011

Gents,we were unable to save the running-configuration of our Nexus7000 due to the error:"Configuration update aborted: another request for config change is already in progress"I was assuming that we were hitting a known bug with the NXOS 5.1.1(a) (C...

Philipp Maihoefer · 09-07-2016

Thanks, I will do so.

Philipp Maihoefer · 06-29-2015

Thanks for the update. I already guessed something like that.

Philipp Maihoefer · 02-02-2012

you should mark this question as answered then. thx!Sent from Cisco Technical Support iPad App

Philipp Maihoefer · 02-02-2012

hi Ronald, be also aware to allow protocol 41 when you bind access list to the interface you are using for the tunnel. happened to me lately cheers philSent from Cisco Technical Support iPad App

Philipp Maihoefer · 10-09-2011

You are right. Rebooting the whole chassis is something i wanted to avoid. In addition this was a bug in the software revision i used. This shouldn't happen again, once you upgraded to > 8.1.3.Phil

Member Since	‎08-15-2007 12:15 AM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	17
Total Helpful Votes Received	5

User Statistics

User Activity

Device Support for Nexus 5648Q in Prime Infrastructure

Symbol Files for Cisco IOS Version

Nexus7k and CFS

ASA-5585-X ipv6 handling

Nexus7K: Standby Supervisor Reboot Failed

Thanks, I will do so.

Thanks for the update. I

Re: ipv6 between nx/os nexus 7K and ASA firewall

Re: Trying to get Tunnel Broker config to work

Re: Nexus7K: Standby Supervisor Reboot Failed