Hello,
I have an ASA5510 which after some time of being unused has been given to me to get going again. When I access the ASA5510 from outside, I get the SSL VPN Service logon screen and when I enter my credentials as prompted get the reported e...
I have a collection of Catalyst 4948s for which I have a general purpose Linux box I have used to span traffic to for subsequent analysis using wireshark.I currently use Cacti for traffic graphing but that application does not provide the visibility ...
I have a pair of 4948's between a Juniper firewall cluster and F5 load blancer pair and traffic through this configuration appreas to be throttled or rate limmited at 100mb, maybe 120mb at most. Traffic is trunked from the Juniper firewalls and set a...
I have a 3550 and 2924xl switch I want to trunk together but am unsuccefule thus far:The 3550 is as follows:Model number: WS-C3550-24-EMISystem image file is "flash:c3550-i5q3l2-mz.121-14.EA1a/c3550-i5q3l2-mz.121-14.EA1a.bincisco WS-C3550-24 (PowerPC...
Normally from the supervisor, I can find the card as follows:Mod Slot Ports Module-Type Model Sub Status--- ---- ----- ------------------------- ------------------- --- --------1 1 2 1000BaseX Supervisor WS-X...
I finally got this sorted out and found the client is not doing clientless access and rather are using the client based remote access.
Once I got a valid copy of the client and imported the needed pcf file, access was successful.
I do have console access. For that matter, browser access to download the ASDM client, is not working either. So, I have a few deficiencies to sort out. I will certainly verify the output of the http service as recommended below. I did originally do ...
What is the step by step process to add a new Anyconnect user? I have an ASA 5510 which was decommissioned and now needs to be put in service. There are existing tunnel and alias settings but I am not clear to the steps to add a new user for the SSL ...
Digi makes a serial port server in 8 or 16 port flavors. I have experience with this and it is a resonably easy device to deploy and use.Raritan also provides a line of serial port servers. I have used the SX-32 model with the Command center platform...
Thanks for the prompt response.With respect to layer 1, we recently replaced all cables as part of a general cleanup and standardization on structureed wiring infrastructure.It was thought cabling might be non-statndard, but, the interfaces in questi...