amitprshad
Level 1
Level 1
Member since ‎03-15-2006
‎08-18-2017

User Statistics

  • 45 Posts
  • 0 Solutions
  • 20 Helpful votes Given
  • 1 Helpful votes Received
Recent Badges
CCP Member
1 Helpful Vote
20 Replies
10 Replies
5 Replies

User Activity

Hi,I am configuring the CME ver 8.6 for FXO ports.My customer has 4 FXO Ports and 1 T1/E1 card.The requirement is..once the PRI goes down then all the calls coming to recpetion should land on the FXO and it should ring on reception phone.My current r...
Hi,I want configure 4 FXO Ports on a CME router.The scenario i am using is that my customer has 1 PRI and if that fails then all the outgoing calls should  go through FXO ports.Also i don't want any incoming calls to come on those FXO ports.Please le...
Hi,I've configured MVA on my H.323 gateway for System Remote Access Using PRI method.Now what happens is that when i place a call from my mobile my MVA IVR works fine and is able to accept "remote destination no" and "password" and asks for pressing...
Hi, My customer has a requirement of dialing a call outside once it hits the IVR similar to MVA feature in CUCM.Hence I’ve created a custom script(attached). Now the problem I am facing is that when try to upload the same script in CUE web page then ...
Hi,I have recently integrated CUE ver 8.0.2 (resident on the voice gateway of branch office) with my CUCM ver 7.1.3.(at headquters).The CTI Ports and CTI route points are showing registered on CUCM.I am trying to use system default aa.aef script in a...
Community Statistics
Member Since ‎03-15-2006 08:41 PM
Date Last Visited ‎08-18-2017 03:54 AM
Posts 45
Helpful Votes Given To