About NoelNesbitt

NoelNesbitt · 04-13-2012

Hi AllI have had a rootle on the forum & support pages and managed to answer some of my questions but if anyone can give me some advice on the following I would be most grateful. I am about to upgrade a CUCM from 8.5.1.13900-5 to 8.6.2.21900-5. And i...

NoelNesbitt · 11-16-2011

Hi All,Hope you can recommend some areas here to look in, because this is drving me crazy!Have inherited a Cisco CUCME 7.1 built on a 2811 router. I have both SIP(7941) and SCCP (7941/7960) handsets, all up and working. (all using 4 digit patterns). ...

NoelNesbitt · 03-03-2011

Dear all,I have a catalist 3550 that seems not to boot up anymore, as soon as I power on the device, all the leds (the 24 Ethernet ports, the Gbic and also the entire set of system leds) are steady green, I have unplagged all of the connected RJ45 ca...

NoelNesbitt · 04-16-2012

Hi Robert,apologies - I did not see your message until after we started the upgrade, but we seem to have had a succesful upgrade but experienced the following:It took about 2.5 hours in total from the time we commited the upgrade to start until we co...

NoelNesbitt · 04-13-2012

HI RobThank you for the confirmation about the LIC - I was fairly sure it would not wipe it out, but the one time I dont check is the one time I get caught out!I did spot the post by Ryan and it did answer a few of the questions I had before I poste...

NoelNesbitt · 04-13-2012

Hi GPMany thanks for the detailed reply.I have run show version active and the line appears as :Active Master Version : 8.5.1.13900-5 without the word UNRESTRICTED so I am going to assume I am running a restricted version of software. (Which is goo...

NoelNesbitt · 11-17-2011

Hi Aaron,Thank you for the quick response, it is much appreciated. I have been working on various phone systems (mitel / meridan/bcm450 and various siemens systems for the last 13 years, so I am not unfamiliar with how recalcitrant phone systems can ...

NoelNesbitt · 03-04-2011

I am starting to think that one of the Fiber cables that I have may be an uncorrect one..... Can it be that a wrong fiber cable connected to the cisco gbic created the problem? The connector look very different from the others looking at it now.........

Member Since	‎03-03-2011 02:21 PM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	8

User Statistics

User Activity

Upgrading CUCM 8.5.1 to 8.6.2 questions

CM Express - Calls from Cisco SCCP to Cisco SIP not working

Catalist 3550 boot problem

Upgrading CUCM 8.5.1 to 8.6.2 questions

Upgrading CUCM 8.5.1 to 8.6.2 questions

Upgrading CUCM 8.5.1 to 8.6.2 questions

Re: CM Express - Calls from Cisco SCCP to Cisco SIP not working

Re: Catalist 3550 boot problem