hI aLL,Where can I buy the Implementing Cisco MPLS v2.3 self stufy guide? I have been looking into cisco press but i cannot find any book with this title.Thanks in advance!

Hi,Most IPV6 BGP configuration i can see both of these commands under router BGPno bgp fast-external-falloverno bgp default ipv4-unicastFrom my understanding "no bgp default ipv4-unicast" is to make bgp advertise ipv4 and ipv6 at the same time if you...

Hi,I have experienced that when I do a show ip bgp command in a public internet routeserver I only see one available path which is the best path for a specific block. Since I am doing multihoming with two ISPs I was expecting two paths incase best pa...

Hi All,I tried configuring policy-map in a fastethernet 0/1 switchport on a cisco 2960 switch. But the configuration doesn't take effect. Once i move the policy-map to the interface vlan it's giving me an error that policy-map cannot be configured on...

Hi All,I am trying to understand how to derive the correct minimum and maximum threshhold for LLQ. For example I have MLPPP with four T1 circuits. And I assign the following.1 percent for class_cs610 percent for class-EF70 percent for class-AF-4110 p...