About rajkamath

rajkamath · 12-24-2022

Hello, We have a setup where a checkpoint interface provides dhcp scope for the voice network IP phones and have a cme router. Firewall interface connected to cisco switch , to which the router and the IP phones are connected. Firwall can ping the IP...

rajkamath · 11-23-2022

Greetings, have a client who wants to do the setup as below. Firewall - int 1 to switch for data vlan, int 2 to switch for voice vlan (both interfaces have been configured with DHCP scopes separately. connected to switch on trunk ports. CME is also c...

rajkamath · 10-21-2022

Greetings, Trying to enable access to voicemail on cisco 7811 using the shortcode 97*. Could someone give guidance to how to go about achieving that. voicemail points to 999.There is a dial peer configured with session target to 192.168.10.10 destina...

rajkamath · 10-20-2022

Good day all, looking at configuring auto attendant on the isr router. any leads on where to start. configured the hunt group.it talks about the commands "param". ios running on the router doesn't seem to have those set of commands. I don't have a CU...

rajkamath · 10-17-2022

Good day, Trying to get a outbound call working through a single line connected to fxo port. first call always works, ( have tested with international, national and mobile ). i hang up and try calling again, it gives a busy tone till i reload the rou...

rajkamath · 12-25-2022

Many thanks Nithin. Would you be kind enough to advise what specific configuration we are looking for. We are not able to ping the router or from router to the switch. It’s as if the interface is completely down. Ports on the switch are configured as...

rajkamath · 11-25-2022

i am getting the ip address for the phones from the firewall. i can ping the firewall interface giving out the IP addresses . however cant reach the cme router. So there is a static route on the switch that is 0.0.0.0 0.0.0.0 10.34.1.1second IP segme...

rajkamath · 10-21-2022

The call goes to IVR and when the user chooses to leave the voice mail, the prompt comes in and works properly. the only issue is with retrieving the message. sh run attached.There is a dial peer to reach the voice mail server. Incoming calls when la...

rajkamath · 10-21-2022

enabled call-park system application under telephony-service and did fac custom voicemail *97.Getting below on the cli for the event.v=0o=Cisco-SIPUA 10870 0 IN IP4 10.90.80.7s=SIP Callb=AS:4064t=0 0m=audio 24180 RTP/AVP 0 8 116 18 101c=IN IP4 10.90....

rajkamath · 10-20-2022

never mind.had to read the doc properly

Member Since	‎09-15-2022 11:19 AM
Date Last Visited	‎02-08-2023 12:49 AM
Posts	33

User Statistics

User Activity

Unable to ping / register to CME gateway

configure ip phones to receive ip from a firewall

configure 97* to access voicemail for sip phones in CME

configure auto attendant on CME 14 on 4321isr

can make only one outbound call and then busy tone - CME using FXO por

Re: Unable to ping / register to CME gateway

Re: configure ip phones to receive ip from a firewall

Re: configure 97* to access voicemail for sip phones in CME

Re: configure 97* to access voicemail for sip phones in CME

Re: configure auto attendant on CME 14 on 4321isr