Hello Steve,
Add the below MPF on ASA apart from the ACL which you need to add on the outside interface should work.
ASA# configure terminal
ASA(config)# policy-map global_policy
ASA(config-pmap)# class class-default
ASA(config-pmap-c)# set connect...
Hello Steve,
Hw wise there are lots of differences. Sw wise it depends what software you're running on 5515 because 8.3 onwards the nat rule and it's implementation changes on ASA. For this traceroute config, the example on the document should work ...
Hello Taran,
Here you go:
http://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-series-next-generation-firewalls/115753-dns-doctoring-asa-config.html
Regards,
Bikram
*Do rate the helpful Posts*
Hello Steve,
This document should answer all your question.
http://www.cisco.com/c/en/us/support/docs/security/pix-500-series-security-appliances/15246-31.html#trace
Let me know if it helps.
Regards,
Bikramjit
...
Hello stvnkelemen,
Get us the below outputs:
1] show dot1x int <> detail
[2] show authentication session interface <>
[3] What kind of authentication are we using for dot1x?
[4] show port-security interface <>
[5] show tech of the switch.
[6]...