About Travis Marzo

Travis Marzo · 10-23-2015

I have a spare 5506w that I am looking to use as an IDS sensor in my environment. We already own a SourceFire license for this box. What I'm looking to do is configure a SPAN port on my 5ks, have the 5506 monitor traffic and report back to my defense...

Travis Marzo · 07-30-2015

I'm having issues connecting the ASA5506w to our WLC. What lightweight image should I be using? I installed the lightweight image of a 702i ap and the BVI interface loses physical connectivity to acquire a dhcp address. I reinstall the autonomous IOS...

Travis Marzo · 06-17-2015

Is it possible to have 1 ISP connected to the Primary ASA and another ISP to the Secondary ASA? Both connections will be active but if one ISP is to fail, all traffic would failover to the active ISP. Can this be accomplished in an Active/Active stat...

Travis Marzo · 04-30-2015

Need help diagnosing a layer 2 networking issue. We had a report from an end user of slow file server access from his computer but local applications were responding normally. No one else was having issues in his area. Port mirrored the employees acc...

Travis Marzo · 10-27-2015

I've never worked with a transparent firewall before. How am I to manage it remotely? I was able to assign an IP address to the management port but unable to ping. I am sitting on the same subnet. I haven't been able to find any articles to point me ...

Travis Marzo · 10-07-2015

The only way I found was to boot AP in rommon and recover the AP from there. I don't remember the exact steps but once in rommon, I was able to set an IP address and tftp an image.

Travis Marzo · 08-21-2015

I had the same problem with the SFR module. Issued a "sw-module module sfr recover stop" and waited a couple mins. Reloaded with "sw-module module sfr recover boot" and was back in business.

Travis Marzo · 07-30-2015

Downloaded the image for a 701e and I'm up and running. BVI interface is now showing as connected and grabbing a DHCP address.

Travis Marzo · 07-01-2015

Instead of using a router, I would like to use 2 switches to split the traffic between the two ASAs. This would give us full redundancy all the way to the ISP. Set the ASAs up in a Active/Passive state. We use IPSLA now for our routes so the configur...

Member Since	‎04-28-2015 08:23 AM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	10

User Statistics

User Activity

AA 5506 as a IDS

ASA5506w connected to vWLC

Dual ISP with Active/Active

Switch sending tcp traffic to incorrect interface

I've never worked with a

The only way I found was to

I had the same problem with

Downloaded the image for a

Instead of using a router, I