About dvag-nsafe

dvag-nsafe · 08-23-2017

Hi there, i have an issue applying an policy-map to an interface. It doesn't give me an error though. My policy is:policy-map POLICY-S4B-USERPORT class CLASS-S4B-VOICE-USERPORT priority level 1 percent 5 police cir percent 5 conform-action transmit...

dvag-nsafe · 08-15-2017

Hi! I have two issues here with QoS on a 3850. 1. I have a policy configured on the uplink to another switch outgoing. i have a client connected to that switch sending DSCP 46 marked packets. When looking a the stats, i see excessive drops on the po...

dvag-nsafe · 07-27-2017

Hi there! I have some questions about configuring QoS on the 3850's. We use them as Access-Switches and have a pair of 6840's to aggregate them. We only have L2 on the 3850, routing is done on the 6840's. Now, i need to configure QoS in the LAN and ...

dvag-nsafe · 06-20-2017

Hi! We currently have a setup where OSPF is condfigured on the SVI's. My Question is simple: OSPF will not notice a failure of the physical links until the dead timer has run out, right? If you configure OSPF on the physical links, OSPF will reroute...

dvag-nsafe · 03-09-2017

Hi again! I have many stacks of 3850-12X48U-L Switches with SW 03.07.04E. I discovered many Ports that show a higher error rate than they actually receive packets: switch#sh int GigabitEthernet1/0/1GigabitEthernet1/0/1 is up, line protocol is up (co...

dvag-nsafe · 02-14-2020

Thanks a lot for taking some time to reply in depth here! Very helpful! TGIF!

dvag-nsafe · 09-14-2017

Hi Julio, i'm still working on this. I have no object-groups anymore in my policy config, but still experience the same issue when trying to apply the policy to the interface:policy-map POLICY-S4B-USERPORT-OUT class CLASS-S4B-VOICE priority level 1 ...

dvag-nsafe · 08-28-2017

Hi, did you ever configure it successfully? I have the same issue. I cannot find any documentation on QoS on a 6840 except for the FEX (instant access modules)...

dvag-nsafe · 08-27-2017

Hi! I was able to applie it, but it didn't show in the configuration. I tried the "all" option, but it still wasn't there. Seems like a bug, as other people seem to have the same issue (found multiple threads here in the forum). When i deleted the po...

dvag-nsafe · 07-27-2017

Hi, i am using iperf to test QoS and i'm trying to set the DSCP values for the traffic i send between the two iperf Laptops. The solution above is not working for me. I checked if the registry entry still exists after the reboot. It does, but i stil...

Member Since	‎04-30-2015 01:00 AM
Date Last Visited	‎06-16-2021 12:04 AM
Posts	21

User Statistics

User Activity

3850: Understanding interface configuration on NM modules

QoS: Output drops and wrong throughput on 3850

Quality of Service on Cisco 3850

OSPF on SVI's rerouting issue

Interface Output drops are higher than the actual output packets

Re: Hi Jon,In addition to your

Re: 3850: Understanding interface configuration on NM modules

Re: Thanks Jon, The link looks

Re: 3850: Understanding interface configuration on NM modules

Hi,